Description

Mono Agricultural Surface Pump (AGM720 A) is a water transfer pump and has been designed to pump water from rivers, dams or tanks to a desired location.
Mono AGM Surface pumping system is designed and manufactured in Australia.
Mono Pumps AGM has been design tested and proven in the field over a wide range of water pumping applications.

7.0HP & 9HP : Pump performance:   2.0 lps @ 80 metres   (1580 gph)     Yanmar
7.0HP & 9HP : Pump performance:   1.5 lps @ 120 metres   (1140 gph)    Yanmar 

13HP : Pump performance:   2.5 lps @ 80 metres   (1980 gph)      Yanmar
13HP : Pump performance:   2.0 lps @ 120 metres   (1580 gph)     Yanmar

SPECIFICATIONS
Operating Temperature: -10 to 40 deg C
pH range 6 to 8.5
Hardness Range 2000 mg/L
Salt Concentration 500 ppm

Rotor Selection – Water Temperature
Standard rotor : 10 to 40 deg C
Mark 3 rotor : 40 to 70 deg C

Mechanical Specification
Suction –  40mm (1 1/2″) Female BSP Internal Thread
Outlet –  40mm (1 1/2″) Female BSP Internal Thread

Direction of Rotation
Anticlockwise when viewed from the motor or bearing housing end.

Materials (Excluding Motor)
Pump Barrel: 304 Stainless Steel
Stator: Natural rubber lining
Rotor: 316 stainless steel
Hard Chrome Plated
Flexishaft: Titanium
Mechanical seal: Carbon/Ceramic/Nitrile:
Mechanical seal holder: 304 Stainless Steel
Discharge Chamber: Cast Iron

Electric Motor
Voltage: 415/3/50 TEFC IP55
Maximum Motor Starts per hour: 10
Note: that if the ambient temperature exceeds 30 deg C it is recommended that the stator and motor be protected from direct sunlight with a well ventilated cover.

Maximum Design Pump Pressure
AGM640 – 3000 kPa

Note: Pumps are capable of much higher pressure if flow of pump is reduced.
Running at over design pressure will reduce the life of the pump.

Manufacturer’s warranty:  2 years   Made in Australia

Additional information