Description

Mono AGM640 is a water transfer pump and has been designed to pump water from rivers, dams or tanks to a desired location
Mono AGM Surface pumping system is designed and manufactured in Australia
Mono Pumps AGM has been design tested and proven in the field over a wide range of water pumping applications

7.0 HP  : Pump performance:   2.0 lps @ 100 meters   (1580 gph)     Kubota 7.0 hp   (800 rpm pump speed)
9.5 HP : Pump performance:   2.5 lps @ 120 meters   (2000 gph)    Kubota 9.5 hp  (1000rpm pump speed)

SPECIFICATIONS
Operating Temperature: -10 to 40 deg C
pH range 6 to 8.5
Hardness Range 2000 mg/L
Salt Concentration 500 ppm

Rotor Selection – Water Temperature
Standard rotor : 10 to 40 deg C
Mark 3 rotor : 40 to 70 deg C

Mechanical Specification
Suction –  40mm Female BSP Internal Thread
Outlet –  40mm Female BSP Internal Thread

Direction of Rotation
Anticlockwise when viewed from the motor or bearing housing end

Materials (Excluding Motor)
Pump Barrel: 304 Stainless Steel
Stator: Natural rubber lining
Rotor: 316 stainless steel
Hard Chrome Plated
Flexishaft: Titanium
Mechanical seal: Carbon/Ceramic/Nitrile:
Mechanical seal holder: 304 Stainless Steel
Discharge Chamber: Cast Iron

Maximum Design Pump Pressure
AGM640 – 3000 kPa

Note: Pumps are capable of much higher pressure if flow of pump is reduced
Running at over design pressure will reduce the life of the pump

Manufacturer’s warranty:  2 years   Made in Australia

Additional information