Description

10″ Standard, 1micron Pleated Sediment Cartridges with maximum flow rate of 35lpm, commonly used in 1st stage of filtration to remove sediment, Rust and Scale
Pleated sediment cartridges have the advantage of a high dirt holding ability with a low pressure drop
Models: Standard
50PP10 – 50 Micron x 10″ – 48 lpm
20PP10 – 20 Micron x 10″ – 45 lpm
5PP10 – 5 Micron x 10″ – 43 lpm
1PP10 – 1 Micron x 10″ – 41 lpm
Models: Jumbo
50PP10J – 50 Micron x 10″ – 100 lpm
20PP10J – 20 Micron x 10″ – 94 lpm
5PP10J – 5 Micron x 10″ – 90 lpm
1PP10J – 1 Micron x 10″ – 88 lpm
Applications:
Drinking water, beverage industry, mineral water bottling, laboratory use, food industry, prefiltration ahead of submicron filters or reverse osmosis and other industrial applications where low contamination levels are needed.
Benefits:
Offer practical filtration with the convenience of a cartridge filter and the economy of cleanability
High surface area construction means longer run length, high flow rates, high dirt holding ability and low pressure drop
Lowest cost per litre filtered
Reusable – can be cleaned under a tap or gentle hosing
Reusability means cartridges cost less to use than disposable depth type cartridges as they can be cleaned several times before replacement is required.
(note: 1- & 5-micron cartridges may only be cleanable once or twice)
Cartridges are thermally bonded to provide integral joints for added strength and long service life
Pleated cartridges are particularly useful for low pressure applications such as domestic supplied using header tanks or roof water

Due to Davey’s Internet Policy this product cannot be purchased online, please contact us in store for sizing and installation advice

IN STOCK